8001 Static Control Surface Mark Remover
3M
Revision date : 2017-07-25
Note: Ingredients listed on restricted chemical lists
EC/CAS
7732-18-5
Name of the chemical
Water, distilled, conductivity or of similar purity H2O
Concentration
80 - 95
General Information
Revision date
2017-07-25
Product name
8001 Static Control Surface Mark Remover
1.2.1 Relevant identified uses
Extra-strength fluid that is designed to remove ordinary dirt and grime as well as difficult spots and stains from all types of static control surfaces., Hard Surface Cleaner
Supplier name
3M
Manufacturer Name
3M
Emergency telephone
1-800-364-3577, (651) 737-6501
Icons in SDS
Company Information
Company name
3M
Section 2
2.1 Classification of the substance or mixture
Serious Eye Damage/Irritation: Category 1. Skin Corrosion/Irritation: Category 1B.
Hazard pictograms
Corrosion |
Hazard statements
Causes severe skin burns and eye damage.
Precautionary statements
General: Keep out of reach of children.
Prevention
Do not breathe dust/fume/gas/mist/vapors/spray. Wear protective gloves, protective clothing, and eye/face protection. Wash thoroughly after handling.
Response
IF INHALED: Remove person to fresh air and keep comfortable for breathing. IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor/physician. Wash contaminated clothing before reuse. IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
Storage
Store locked up.
Disposal
Dispose of contents/container in accordance with applicable local/regional/national/international regulations.
2.3 Other hazards
May cause chemical gastrointestinal burns. 2% of the mixture consists of ingredients of unknown acute inhalation toxicity.
