Product name
Antimony ICP-MS Standard
Supplier name
AccuStandard, Inc
Emergency telephone
AccuStandard, Inc
Icons in PDF
Company name
AccuStandard, Inc
E-mail address of the competent person responsible for the Safety Data Sheet
edocs@accustandard.com
Signal word
Danger
Hazard statements(CLP)
H290, H302, H314, H318
Code
Statements
H290
May be corrosive to metals
H302
Harmful if swallowed
H314
Causes severe skin burns and eye damage
H318
Causes serious eye damage
Code
Statements
P202
Do not handle until all safety precautions have been read and understood.
P233
Keep container tightly closed.
P262
Do not get in eyes, on skin, or on clothing.
P264
Wash ... thoroughly after handling.
P280
Wear protective gloves/protective clothing/eye protection/face protection.
P284
[In case of inadequate ventilation] Wear respiratory protection.
P331
Do NOT induce vomiting.
P338
Remove contact lenses, if present and easy to do. Continue rinsing.
P340
Remove victim to fresh air and keep at rest in a position comfortable for breathing.
P352
Wash with plenty of water/...
P404
Store in a closed container.
2.2 Label elements
0 2 HEALTH 2 0 FLAMMABILITY - continued P284 - Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure. P331 - Ingestion: Do NOT induce vomiting. Call a physician or poison control center immediately. Give victim a glass of water a little at a time. Never give anything by mouth to an unconscious person. If vomiting occurs spontaneously, lower head below waist to prevent fluid from entering the lungs. P338 - Eye contact: Immediately flush with plenty of water. After initial flushing, remove and contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. P340 - Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention. P352 - Skin contact: Wash thoroughly with soap and water. Get medical attention if irritation develops or persists.
Signal word
Danger 0
Hazard statements
H290 - May be corrosive to metals. H302 - Harmful if swallowed. (Acute toxicity, oral, category 4) H314 - Causes severe skin irritation. (Category 1B) H318 - Causes serious eye damage. (Eye damage/irritation, category 1) Precautionary Codes: P202 - This product should only by used by persons trained in the safe handling of hazardous chemicals. P233 - Store in a tightly closed container. (P404) P262 - Do not get in eyes, on skin or clothing. P264 - Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. P280 - Protective gloves must be worn to prevent skin contact. - continued
2.3 Other hazards
2.2.1 - Symptom of Exposure Health/Environment Depending on the intensity and duration of exposure, effects may vary from mild irritation to severe destruction of tissue. May be corrosive to metals.
Potential health effects
Causes serious eye damage. (Eye damage/irritation, category 1) Causes severe skin irritation. (Category 1B) May be harmful if absorbed through the skin. (Acute toxicity, dermal, category 5) May be harmful if inhaled. (Acute toxicity, inhalation, category 5) Harmful if swallowed. (Acute toxicity, oral, category 4) 2.2.3 - Routes of Entry Inhalation, ingestion or skin contact. 2.2.4 - Carcinogenicity This product is or contains a component that is not listed (ACGIH, IARC, NTP, OSHA) as a cancer causing agent.