SS-81061-3-100MG

AccuStandard, Inc

GHS07
Health risk rating2
Safety risk rating1
Environmental risk rating1

General Information

Product name

SS-81061-3-100MG

Supplier name

AccuStandard, Inc

Emergency telephone

AccuStandard, Inc

Icons in PDF

GHS07

Company Information

Company name

AccuStandard, Inc

E-mail address of the competent person responsible for the Safety Data Sheet

edocs@accustandard.com

GHS Information

Signal word

Warning

Hazard Codes

Hazard statements(CLP)

H315, H320, H335

Hazard statements

Code

Statements

H315

Causes skin irritation

H320

Causes eye irritation

H335

May cause respiratory irritation

Precautionary statements

Code

Statements

P202

Do not handle until all safety precautions have been read and understood.

P233

Keep container tightly closed.

P262

Do not get in eyes, on skin, or on clothing.

P264

Wash ... thoroughly after handling.

P280

Wear protective gloves/protective clothing/eye protection/face protection.

P284

[In case of inadequate ventilation] Wear respiratory protection.

P338

Remove contact lenses, if present and easy to do. Continue rinsing.

P360

Rinse immediately contaminated clothing and skin with plenty of water before removing clothes.

P404

Store in a closed container.

Section2

SECTION 2: Hazards identification

2.2 Label elements

0 1 HEALTH 1 0 FLAMMABILITY - continued P284 - Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure. P338 - Eye contact: Immediately flush with plenty of water. After initial flushing, remove and contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. P360 - Skin contact: Immediately wash skin with soap and plenty of water. Remove contaminated clothing. Get medical attention if symptoms occur. Wash clothing before reuse.

Signal word

0

Hazard statements

H315 - Irritating to skin. (Skin corrosion/irritation, category 2) H320 - Irritating to eyes. (Eye damage/irritation, category 2B) H335 - May be irritating to mucous membrane and upper respiratory system. (Specific target organ toxicity, single exposure; Respiratory tract irritation, category 3) Precautionary Codes: P202 - This product should only by used by persons trained in the safe handling of hazardous chemicals. P233 - Store in a tightly closed container. (P404) P262 - Do not get in eyes, on skin or clothing. P264 - Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. P280 - Protective gloves must be worn to prevent skin contact. - continued

2.3 Other hazards

2.2.1 - Symptom of Exposure Health/Environment May cause nausea, vomiting, and diarrhea. Suspected endocrine toxicant: May cause diseases such as hypothyroidism, diabetes mellitus, hypoglycemia, reproductive disorders, and cancer.

Potential health effects

Irritating to eyes. (Eye damage/irritation, category 2B) Irritating to skin. (Skin corrosion/irritation, category 2) May be harmful if absorbed through the skin. (Acute toxicity, dermal, category 5) May be irritating to mucous membrane and upper respiratory system. (Specific target organ toxicity, single exposure; Respiratory tract irritation, category 3) May be harmful if inhaled. (Acute toxicity, inhalation, category 5) May be harmful if swallowed. (Acute toxicity, oral, category 5) 2.2.3 - Routes of Entry Inhalation, ingestion or skin contact. 2.2.4 - Carcinogenicity This product is or contains a component that is not listed (ACGIH, IARC, NTP, OSHA) as a cancer causing agent.

Ready to get started with your SDS library?
You can be up and running in minutes with our 30 day free trial.