PLAS-AX-051N

AccuStandard, Inc

GHS07GHS08
Health risk rating5
Safety risk rating1
Environmental risk rating1

General Information

Product name

PLAS-AX-051N

CAS No.

13927-77-0

Supplier name

AccuStandard, Inc

Emergency telephone

1-203-502-7070, +001-203-502-7070

Icons in PDF

GHS07GHS08

Company Information

Company name

AccuStandard, Inc

E-mail address of the competent person responsible for the Safety Data Sheet

edocs@accustandard.com

GHS Information

Signal word

Danger

Hazard Codes

Hazard statements(CLP)

H315, H317, H334, H335, H350

Hazard statements

Code

Statements

H315

Causes skin irritation

H317

May cause an allergic skin reaction

H334

May cause allergy or asthma symptoms or breathing difficulties if inhaled

H335

May cause respiratory irritation

H350

May cause cancer

Precautionary statements

Code

Statements

P202

Do not handle until all safety precautions have been read and understood.

P233

Keep container tightly closed.

P235

Keep cool.

P262

Do not get in eyes, on skin, or on clothing.

P264

Wash ... thoroughly after handling.

P284

[In case of inadequate ventilation] Wear respiratory protection.

P338

Remove contact lenses, if present and easy to do. Continue rinsing.

P360

Rinse immediately contaminated clothing and skin with plenty of water before removing clothes.

P404

Store in a closed container.

Section2

SECTION 2: Hazards identification

2.2 Label elements

0 2 HEALTH 2 0 FLAMMABILITY - continued P202 - This product should only by used by persons trained in the safe handling of hazardous chemicals. P233 - Store in a tightly closed container. (P404) P235 - Store in a cool dry place. P262 - Do not get in eyes, on skin or clothing. P264 - Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. P284 - Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure. P338 - Eye contact: Immediately flush with plenty of water. After initial flushing, remove and contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. P360 - Skin contact: Immediately wash skin with soap and plenty of water. Remove contaminated clothing. Get medical attention if symptoms occur. Wash clothing before reuse.

Signal word

Danger 0

Hazard statements

H315 - Irritating to skin. (Skin corrosion/irritation, category 2) H317 - May cause allergic skin reaction. (Sensitization, skin, category 1) H334 - May cause allergic respiratory reaction. (Sensitization, respiratory, category 1) H335 - May be irritating to mucous membrane and upper respiratory system. (Specific target organ toxicity, single exposure; Respiratory tract irritation, category 3) H350

2.3 Other hazards

2.2.1 - Symptom of Exposure Health/Environment May cause allergic respiratory reaction. (Sensitization, respiratory, category 1) May cause allergic skin reaction. (Sensitization, skin, category 1)

Potential health effects

May be irritating to eyes. Irritating to skin. (Skin corrosion/irritation, category 2) May be harmful if absorbed through the skin. (Acute toxicity, dermal, category 5) May be irritating to mucous membrane and upper respiratory system. (Specific target organ toxicity, single exposure; Respiratory tract irritation, category 3) May be harmful if inhaled. (Acute toxicity, inhalation, category 5) May be harmful if swallowed. (Acute toxicity, oral, category 5) 2.2.3 - Routes of Entry Inhalation, ingestion or skin contact. 2.2.4 - Carcinogenicity

Ready to get started with your SDS library?
You can be up and running in minutes with our 30 day free trial.