ALR-155N

AccuStandard, Inc

GHS07
Health risk rating2
Safety risk rating1
Environmental risk rating1

General Information

Product name

ALR-155N

CAS No.

99-50-3

Supplier name

AccuStandard, Inc

Emergency telephone

AccuStandard, Inc

Icons in PDF

GHS07

Company Information

Company name

AccuStandard, Inc

E-mail address of the competent person responsible for the Safety Data Sheet

edocs@accustandard.com

GHS Information

Signal word

Warning

Hazard Codes

Hazard statements(CLP)

H315, H320

Hazard statements

Code

Statements

H315

Causes skin irritation

H320

Causes eye irritation

Precautionary statements

Code

Statements

P202

Do not handle until all safety precautions have been read and understood.

P233

Keep container tightly closed.

P235

Keep cool.

P260

Do not breathe dust/fume/gas/mist/vapors/spray.

P262

Do not get in eyes, on skin, or on clothing.

P264

Wash ... thoroughly after handling.

P280

Wear protective gloves/protective clothing/eye protection/face protection.

P284

[In case of inadequate ventilation] Wear respiratory protection.

P338

Remove contact lenses, if present and easy to do. Continue rinsing.

P340

Remove victim to fresh air and keep at rest in a position comfortable for breathing.

P352

Wash with plenty of water/...

P404

Store in a closed container.

Section2

SECTION 2: Hazards identification

2.2 Label elements

0 1 HEALTH 1 0 FLAMMABILITY - continued P280 - Protective gloves must be worn to prevent skin contact. P284 - Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure. P338 - Eye contact: Immediately flush with plenty of water. After initial flushing, remove and contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. P340 - Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention. P352 - Skin contact: Wash thoroughly with soap and water. Get medical attention if irritation develops or persists.

Signal word

0

Hazard statements

H315 - Irritating to skin. (Skin corrosion/irritation, category 2) H320 - Irritating to eyes. (Eye damage/irritation, category 2B) Precautionary Codes: P202 - This product should only by used by persons trained in the safe handling of hazardous chemicals. P233 - Store in a tightly closed container. (P404) P235 - Store in a cool dry place. P260 - Do not breathe dust. P262 - Do not get in eyes, on skin or clothing. P264 - Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. - continued

2.3 Other hazards

2.2.1 - Symptom of Exposure Health/Environment To the best of our knowledge the chemical, physical and toxicological properties of the component ingredients have not been thoroughly investigated, however, exposure to any chemical should be kept to a minimum.

Potential health effects

Irritating to eyes. (Eye damage/irritation, category 2B) Irritating to skin. (Skin corrosion/irritation, category 2) May be harmful if absorbed through the skin. (Acute toxicity, dermal, category 5) Irritating to mucous membrane and upper respiratory system. May be harmful if inhaled. (Acute toxicity, inhalation, category 5) May be harmful if swallowed. (Acute toxicity, oral, category 5) 2.2.3 - Routes of Entry Inhalation, ingestion or skin contact. 2.2.4 - Carcinogenicity This product is or contains a component that is not listed (ACGIH, IARC, NTP, OSHA) as a cancer causing agent.

Ready to get started with your SDS library?
You can be up and running in minutes with our 30 day free trial.