DTM Wash Primer

THE SHERWIN-WILLIAMS COMPANY

Revision date : 2021-04-14


GHS08
Health risk rating 1
Safety risk rating 1
Environmental risk rating 1

Note: Ingredients listed on restricted chemical lists

EC/CAS

14807-96-6

Name of the chemical

Talc

Concentration

N/A

Listed in

EC/CAS

7631-86-9

Name of the chemical

Silver adsorbed on silicon dioxide

Concentration

N/A

EC/CAS

14808-60-7

Name of the chemical

Silica, crystalline

Concentration

N/A

Listed in

General Information

Revision date

2021-04-14

Product name

DTM Wash Primer

1.2.1 Relevant identified uses

Paint or paint related material

Manufacturer Name

THE SHERWIN-WILLIAMS COMPANY

Emergency telephone

US / Canada: (800) 424-9300

Icons in SDS

Company Information

Company name

THE SHERWIN-WILLIAMS COMPANY

GHS Information

Signal word

Danger

Section 2

SECTION 2: Hazards identification

29 CFR 1910.1200) OSHA/HCS status : This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200).

2.1 Classification of the substance or mixture

CARCINOGENICITY - Category 1A SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 1

Signal word

Danger

Hazard statements

May cause cancer. Causes damage to organs through prolonged or repeated exposure. (lungs)

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves, protective clothing and eye or face protection. Do not breathe vapor. Do not eat, drink or smoke when using this product. Wash thoroughly after handling.

Response

IF exposed or concerned: Get medical advice or attention.

Storage

Store locked up.

Disposal

Dispose of contents and container in accordance with all local, regional, national and international regulations.

Supplemental label elements

WARNING This product contains chemicals known to the State of California to cause elements cancer and birth defects or other reproductive harm. FOR INDUSTRIAL USE ONLY. Adequate ventilation required when sanding or abrading the dried film. If Adequate ventilation cannot be provided wear an approved particulate respirator (NIOSH approved). Follow respirator manufacturer's directions for respirator use. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of the dry film may release Crystalline Silica which has been shown to cause lung damage and cancer under long term exposure. This product contains a Significant New Use Rule (SNUR) Chemical. Do not allow this product to enter drains, sewers, wastewater treatment systems, groundwater, streams, lakes or ponds. See Environmental Data Sheet (EDS) for additional details. Please refer to the SDS for additional information. Keep out of reach of children. Do not transfer contents to other containers for storage.

2.3 Other hazards

None known.

Ready to get started with your SDS library?
You can be up and running in minutes with our 30 day free trial.